Lisa D. asked
I have a Kenmore two oven range model#790.99513305. The main oven is not working in bake, broil, or convection. The digital reading will not go past 100 and there is no heat in the oven. The side oven works fine. I need to know what part to order to fix it.
August 5th, 2023
Scott M. answered
The most likely cause of the main oven not working in bake, broil, or convection is the high limit t...
August 5th, 2023
Create an account to view answers and interact with the community!
I have a Frigidaire front loader washing machine that drains for a few seconds then stops, and it won't fill with water. The water valves have good pressure, and when set to drain/spin, it will start to drain for a second, stop, then turn the drum slowly for about a minute before stopping. The pump sounds louder than normal, and there is water in the tub. The door locks, and the control panel lights remain lit, but the drum stops. What could be causing this issue, and what steps should I take to diagnose and fix it?
February 18th, 2024
My GE Monogram built-in side-by-side refrigerator is freezing food in the fresh food section and going too cold in the freezer. The unit is about 6 years old. What could be the issue and how can I fix it?
November 6th, 2024
We have a 4-year-old Whirlpool ARC 5555 fridge. The freezer on the bottom cools fine, but the top fridge section is at 50°F. The compressor runs and the back coils get hot. Are there separate cooling coils embedded in the fridge section, or does it all cool from the visible coils in the freezer box? If there are separate coils, why would the fridge section not cool while the freezer works fine? What could be the typical cause of this issue?
March 31st, 2024
We have a Haier fridge where water accumulates in the freezer door and snow piles up at the back of the fridge. The top shelf and even the crisper at the bottom are freezing items. Today, we found a hole with a ton of ice built up, which we cleared out. We need to know how to defrost the heater and where it is located.
November 23rd, 2023
I have a Kenmore front load washer that is only 2 years old. From day one, the fill cycle has acted strangely. When the washer starts to fill, the water valve opens and closes very quickly, not letting much water in. This causes the washer hoses to jump around due to the rapid opening and closing of the valves. I'm concerned about the hydraulic shock damaging the hoses. After the fill cycle, the laundry does not seem very wet, and I don't think it's getting enough water to clean properly. My older front load washer does not act this way. What could be causing this issue and what can be done to fix it?
July 19th, 2024