Michael F. asked
I have a Samsung Fridge RF4287HARS and it appears that the freezer temperature sensor has become severed from wherever it is supposed to be connected to on the fridge. There is the sensor, and then two yellow cords which lead to a plug -- that side of the plug appears to be fine. This plugs into another plug which only has two wires -- one red one grey which appear to have been cut somehow. Where does this go? Is it repairable? If necessary, what part(s) do I need? And what needs to be done to replace it?
November 20th, 2024
Ann R. answered
The issue with the severed freezer temperature sensor in your Samsung Fridge RF4287HARS appears to b...
November 20th, 2024
Create an account to view answers and interact with the community!
I have a Whirlpool W10290341A dishwasher that won't wash. The 'start' button goes on for a moment, then goes off, and the 'clean' light continually flashes. The 'cancel' button stays on and makes sounds like the machine is running, but it doesn't seem to do anything productive. Any ideas?
May 2nd, 2023
Hi - Kenmore wash machine model # XXXXX seems very lose inside - I took cabinet off - all suspension springs in tact. Seems lose at the base - to much play. What could be causing this issue and how can it be fixed?
December 29th, 2023
My GE Profile oven will not accept commands from the electronics. It displays 'LOC' whenever I try to bake. I did not self-clean recently. I was attempting to go to the Shabbats mode when it stopped responding. What should I do?
August 8th, 2024
My Cambria dryer lights up but won't start. It says 'sensing' but won't start. What should I do?
July 1st, 2024
My washer goes through all cycles fine, but when it's time to spin, it either goes really slow or doesn't spin at all. Sometimes, I can turn it by hand to get it going. I initially thought it might be the motor couplings, so I replaced them, but the issue persisted. When I tried it again, it seemed to spin briefly but then stopped and started smelling like something was burning. What could be the problem?
September 10th, 2023