Alicia J. asked
I have an Amana DLW330RAW washer. The washer burnt a belt. I replaced the belt and watched the first cycle on the new belt for problems. When reaching the spin cycle, the motor pulley continues to spin and pump but the spin pulley under the tub stops. This is causing the belt to stop and it is burning up on the one moving pulley. Both pulleys turn freely by hand. Any suggestions?
September 2nd, 2024
Matthew W. answered
The issue might be related to the belt tensioner, the belt length, or the through-out bearing. Here ...
September 2nd, 2024
Create an account to view answers and interact with the community!
My refrigerator/freezer is not cooling properly. The refrigerator is set at level 7 and the freezer at level 6. There is frost buildup in the freezer, but not heavily on the backwall panel. No air is coming out of the vent in the refrigerator. The model is Hotpoint HSS25GFTA WW with serial number ML248550. What could be the issue and is there anything I can do until I can get a service technician?
July 27th, 2024
Hi, I have a Whirlpool HT Front load washer GHW9400PW, serial# XXXXX. Twice now, early in the wash mode, it has beeped and alternated with an "F". I have cancelled the wash several times and tried to reset the wash. What does the "F" mean and what can I do to repair it?
April 6th, 2023
My Bakers Pride model GDCO-G1 burner is not burning clean. Half of the oven inside has black residue on the bottom, and the right burner flame is yellow/orange, while the left burner flame is blue. The convection oven is only 5 months old. How can I fix this and adjust the air mixture for the burners?
July 28th, 2023
I have a 420 series Kenmore water softener. I am getting colored water in my sinks. I am told it's a screen in the resin tank that needs to be replaced. Is that possible, or should I replace the tank? How much are they?
March 19th, 2024
I have a Maytag washer Model No. MAH5500BWW. It shows a fault code (nd). Can you tell me what the code means? The washer seems to cycle through, but no water enters or leaves the tank.
November 4th, 2023