asked
I own a Charmglow 4000 double burner propane grill and the scroll cart. The inside of the grill was air blasted by a professional company, but they caused small holes in the cast aluminum. I'm considering using JB Epoxy to fill in these holes from above and below, smooth and sand them, and then re-prime the grill. JB Epoxy claims it can withstand engine block heat. Is this a viable solution, or do you have any alternative suggestions?
January 16th, 2023
Replaced the transmission, washer spins off balance now even when empty. All springs are good and in the proper places, motor coupling was also replaced, washer is level, clutch replaced recently also, but still spins off balance. What could be the cause?
August 31st, 2023
My Bosch dishwasher model SMU8802UC/U12 has a soap dispenser door that won't stay shut. The door moves freely and makes a 'clicking' noise similar to an old-style light switch, but it doesn't make any humming noise or feel forced open. What could be the issue and how can it be fixed?
January 12th, 2024
My GE refrigerator has no voltage to the inlet water pump. It stopped working six months ago, and after turning the water back on last night, it worked for three ice cycles before stopping again. What could be the issue?
October 30th, 2024
My electric dryer is not heating up anymore. It runs and blows air, but it doesn't heat up to dry clothes. What could be the issue, and what steps should I take to diagnose and potentially fix the problem?
August 30th, 2023
My Whirlpool washer model WFW8400TW00 has been problematic for the past week. It started by not turning on any cycles and only giving a few fast beeps. I ran a self-diagnostic test and got an F01 code, indicating a need to change the CCU board. I replaced the board, but it still beeps as before. The test now stops at the rinse/spin light and doesn't proceed further. What could be the issue and how can I fix it?
October 9th, 2024