Monica H. asked
My dryer control system won’t work. It's showing a control 'ooo' icon and I can’t change the settings with the knob nor with the buttons. It will only turn on & off. What's the brand and model of your dryer? How old is it? How long has this been going on with your dryer? What have you tried so far?
December 27th, 2023
Melissa M. answered
The issue with your dryer's control system could be resolved by performing a reset on the appliance....
December 27th, 2023
Create an account to view answers and interact with the community!
My Frigidaire ice maker Efic103 is making one large ice sheet instead of individual pieces. It started yesterday, and I have tried turning it off and on, and changing sizes. The ice maker is a month old and was a Christmas present.
August 24th, 2023
I have a KitchenAid refrigerator model KRFC302ESS00. The Door Alarm beeps as if the doors aren't closed, but they are. After 5 minutes of beeping, it stops, but the lights don't turn on. The refrigerator still cools. I've read that the doors might not be properly aligned, but they seem level and I've tightened the bolts. What should I do next?
January 2nd, 2024
I have a WP electric dryer model WED5300VW0 that won't start. I've verified mains voltage, tested sensors, switches, and thermostats with a VOM, and tested the motor with a test cable. The timer makes a 'ticking' sound when in a cycle range but no sound when in an Off position. I've also tested the thermal fuse, start switch, door switch, and temp sensors with a VOM. I'm considering replacing the timer to see if it's the root cause of the stoppage. Additionally, there's a small circuit board in the console to the left of the start switch that I can't find information about. Can you advise on what else I can do and the function of this circuit board?
December 11th, 2024
How much is my 1938 Vulcan gas stove in good condition worth?
January 4th, 2023
My Kenmore dishwasher model # 665.13833K600, which is about 12-13 years old, fills with water, starts to run normally, but at the end of the cycle, the dishes are dirty. I've checked the fill valve, float switch, and replaced the pump assembly and chopper. The old motor ran fine when powered up. The dishwasher sometimes not cleaning, then fine, then not cleaning. It fills and starts to run normally, then after a few minutes it quiets down. When I open the door, no visible water inside, but can hear the pump running. The drain hose has a high loop under the sink, and the check valve in the drain hose at the pump appears to function as it should. What could be the issue and what should I check next?
October 27th, 2024
