Christopher P. asked
My dryer's igniter stays lit for about 45 seconds, then the flame stays on for 20 seconds before going out. I've changed the gas coils and the gas valve, but the issue persists. The igniter has been burning for about 3 minutes without igniting the flame, and the front cover is off. What could be the problem?
September 5th, 2024
Karen D. answered
The issue you're experiencing is likely due to a faulty flame sensor. Here are the steps to diagnose...
September 5th, 2024
Create an account to view answers and interact with the community!
My Kitchenaid 'Superba?' KUDS01FL dishwasher works great but won't start after sitting for a while. The LEDs do not blink to indicate the start of a cycle, but the cancel cycle always works. The machine will usually run any program after reassembling the door/control panel. Does this machine have a memory that can be cleared?
February 14th, 2023
My Miele dishwasher works most of the time, but sometimes it stops before the soap dispenser opens and the INTAKE/DRAIN light flashes. It usually works if we start it again. Can you diagnose this problem?
September 6th, 2024
I have a Samsung dishwasher model # ***** that always stops and starts flashing 'smart auto' no matter what wash mode I set. I have tried resetting it by shutting off the power, but it didn't work. The manufacturer suggested it might be a water supply fault code, but my water supply is fine. The dishwasher supplies water for 3-5 seconds, then drains for another 3-5 seconds before stopping and flashing the code. What could be causing this issue and how can I fix it?
September 4th, 2023
My LG Refrigerator Model #LMX25981ST is showing an Er 1F error on the control panel, but the fridge is working normally and the freezer drawers are fine. I cannot set the temperature and have tried resetting it by unplugging the fridge for 10 seconds and plugging it back in. What could be causing this error and how can I fix it?
March 6th, 2023
Kenmore Elite 665.13153k701 dishwasher has no power to the inlet valve and doesn't fill. The inlet valve has been replaced, there is water pressure at the valve, the line is not clogged, and a voltmeter test shows no voltage when the valve should be open, with no sound of relay operation or vibration.
June 26th, 2024