Monique T. asked

🔌  Appliance

My Electric Maytag clothes dryer only spins during the wrinkle prevent cycle. The timer goes through other cycles but nothing happens. What parts should I check?

April 3rd, 2024

Charlotte O. answered

The issue is likely with the timer itself, specifically the internal contacts. This part will need t...

April 3rd, 2024

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

I have a Jenn Air JDS9860AAP. The oven was not heating up properly. Sears replaced a board behind the clock, but that didn't solve the problem. Now they think it is the aux relay. They had the part sent to my house and I want to try and fix this on my own. I have the back panel off and found what needs to be replaced, but I cannot figure out how to get the wires out of the old relay. Is there a trick to getting them out?

October 9th, 2023

My control light is stuck on and none of the other buttons will take it off. It stopped with a load of jeans in it. There is water still in the machine, so it did not spin out yet. Help. It's a Maytag 5 years old, front loader.

August 31st, 2024

I have a Danby Beverage Fridge, model DBC039A1DBD, which is inoperative. The only functioning part is the blue digital temperature readouts, which are adjustable. There is no interior light, compressor operation, or fan operation. I have checked for 120VAC at the distribution block before the power goes to the thermostat, removed the door switch and used a jumper, and checked for voltage across the switch wires, which showed no voltage. The switch has good continuity in both normal and depressed positions. Should I return the fridge for a refund?

July 14th, 2023

I have a Jennair electric slide-in oven that is about 2 years old. The BAKE function won't turn on and the display keeps switching to the KEEP WARM function. What could be causing this issue and how can it be fixed?

August 31st, 2023

My Frigidaire front load washer model GSTF1670AS0 has been taking almost 3 hours to finish a load due to slow water filling. I've checked the inlet hoses and they are clean. What should I do next?

May 20th, 2024