When starting my Whirlpool WED9600TW1 Dryer, the dryer attempts to start, then stops. The Start button is still illuminated. I have to open the door and press start again, sometimes up to 5 times to get the dryer running. I also get the F01 Fault code sometimes. I am planning to do the work myself and have already inspected the control board and did a solder repair to one of the solder points, but the F01 fault persists. What could be the issue and how can I resolve it?

March 9th, 2023

My KitchenAid appliance shuts down and can't drain. It just started happening in the last three times it didn't finish its full cycle. I plan to do the work myself. What kind of appliance is this, and do you have a model number so I can better assist you?

September 13th, 2024

My Whirlpool Cabrio washer (WTW6200SW0) makes a dull 'thunk' noise during the initial wash and more prominently between the wash and final rinse cycle. I have replaced the agitator dogs and the basket suspension. The washer works fine until it reaches the final spin (at the 13-minute mark on the readout), where it stops and makes the periodic thunk noise. If I manually change it to rinse/spin, it finishes the load without issue. What could be causing this noise, and what should I check?

January 31st, 2024

I have a GE gas stove, model PGB910SEM1SS, which is about 6 years old. The medium and extra-large burners do not ignite by themselves, but they start and burn evenly when I use a lighter. What should I do?

February 16th, 2024

Our Maytag top loading washer fills and runs until the final 9 minutes on any cycle, then it gives the LF error message. The water flow isn't the issue, it only gives the LF message at the 9 minutes mark, it fills fine to wash the clothes, but doesn't finish the cycle. We've taken to hose off and cleaned the filters. It is still doing it. What else can we try?

December 11th, 2024