Jacob B. asked
My GE dishwasher GDT645SYNFS is showing an 'H2O' error code after 2 minutes into the cycle. I replaced the water inlet valve a few days ago and checked the water supply, which has strong pressure. What could be causing this issue and what should I check or replace?
December 28th, 2024
Patrick B. answered
The issue is likely due to the pressure switch below the tub not reading the water fill cycle proper...
December 28th, 2024
Create an account to view answers and interact with the community!
I have a GE front load clothes washer. After replacing the seal and three struts, the inner basket seems to be loose. The basket has a lot of play up and down and there’s a good size gap between it and the outer tub. What could be the issue and what parts might need to be replaced?
February 1st, 2023
My Kenmore HE2 Plus front-load washer, which is 12 years old, turns on, locks the door, and then shuts off after a few minutes. I've cleaned the drain filter and replaced the electronic control board, but now it fills with water, agitates, but won't spin or drain, and there are no error codes. What could be the issue, and is it worth fixing?
February 16th, 2024
How do I get the trap out and cleaned on my Samsung front-loading washer, which is approximately 4 years old?
May 1st, 2023
I have a Kenmore Elite front-loading washer, model 110 45996, purchased in 2004. The display is flashing 'F' and 'dL'. I turned it off using the cancel button and tried to restart it several times, but it doesn't start. What could be the issue and what should I do?
October 11th, 2024
My Whirlpool WED5100VQ1 dryer only heats during automatic dry, not in timed dry. How can I test to figure out what is wrong? I previously diagnosed a bad timer by checking continuity from a terminal to C, but this model has a timed dry without high heat. The temperature level is on another switch. How should I proceed with checking this dryer?
February 6th, 2024
