Russell M. asked

🔌  Appliance

My GE washer starts and fills with water, but won't go into the wash cycle, times through the wash cycle without movement, and then starts pumping water out but doesn't go into the spin cycle. What could be the issue and how can it be fixed?

September 5th, 2024

Katie H. answered

The issue is likely due to a faulty lid switch or motor control board. Here are the steps to diagnos...

September 5th, 2024

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

My F&P GWL 15 washer was having trouble spinning and would pump out about half the water then stop. After checking the pump and restarting, it filled with water, agitated, and then quit, with no lights or power. What could be the issue and what should I do?

April 18th, 2023

I was washing lightweight rugs in my older washing machine when it started to smoke during the rinse cycle. Additionally, my older refrigerator is dripping water in the area where food and drinks are located, and the water is then freezing. What could be causing these issues, and what steps can I take to address them?

May 11th, 2024

We have a GE side-by-side refrigerator, model GSL25JFRF BS, purchased in July 2005. About 18 months ago, the water dispenser stopped working, but it seems to work during the summer. We tried adjusting the lower crisper and using a foam board, which worked once but not consistently. We replace the filter every 6 months and get plenty of ice cubes but no water. Is there a dispenser heater we could install, and what could be causing this issue?

March 31st, 2024

My GE dryer DBSR463EG0WW will start when I press the start switch, but it stops when I release the switch. I replaced the start switch, tested the door switch, and replaced the centrifugal switch on the motor, but the issue persists. What could be causing this problem and what should I check next?

July 31st, 2023

My LG gas dryer is not heating the air. I have cleaned out the filter, vent line, and vacuumed the vent areas. The gas line seems okay. What could be the issue and what steps should I take to diagnose and fix it?

November 25th, 2024