Tyler R. asked

🔌  Appliance

My Kenmore Oasis Elite dryer is not completely drying clothes during a cycle. I have checked for blockages, replaced the ignitor, coils, thermistor, and thermostat, and verified their continuity. I also replaced the control panel, but I cannot enter test mode to check for codes. What could be the issue and what else can I check?

May 18th, 2024

Brianna S. answered

The issue is likely due to a failure in the main control board, which is similar to the BIOS chip in...

May 18th, 2024

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

I have a stacked washer/dryer unit, model 417.97312704 (possibly 417.97812704). The dryer works, but the washer does not fill, wash, or spin. The 'open lid' safety lock-out appears to be working, and the machine may have been improperly loaded (unbalanced) just before the problem presented. What could be causing this issue and what should I check next?

April 1st, 2024

I just bought a used Maytag Neptune model MAH 5500BWW and it isn't spinning out completely. The clothes are still wet after the cycle. I suspect something might be jarred or not level from moving it. What could be causing this issue and what can I check?

March 14th, 2023

I have a GE top loader washer model # XXXXX that flooded due to a failed sump. After drying and re-energizing, the washer fills and drains but won't spin or agitate. I've replaced the motor and control panel board, checked continuity on the lid switch, and tried resetting by opening/closing the lid. No error codes are showing, and I suspect the shaft/mode controller might be damaged. What else can I check or replace to resolve this issue?

June 27th, 2024

My Maytag dryer model #XXXXX 5500 AYW isn't starting. The thermal fuse, high limit on the element, thermistor next to the thermal fuse on the blower housing, and door latch are all functioning correctly. What could be the issue, and how can I troubleshoot it further?

July 7th, 2024

I have a Whirlpool dishwasher DU1055, 5 years old. It was working fine until this morning when the cancel light and the normal light started blinking. I tried unplugging and plugging it back in, but the normal light still blinks. The buttons don't respond, and there's no beep when pressed. The normal light blinks fast, and the control locked light is not lit. What could be the issue, and how can I fix it?

July 24th, 2023