Richard H. asked

🔌  Appliance

My refrigerator's drain pan is overflowing, and it fills to overflow about 4-5 days after each time all the water is removed. The evaporator fan is running, the coils have been cleaned, and the fan in the rear appears to be working fine. What could be causing this issue?

December 1st, 2023

James B. answered

The overflowing drain pan issue is not related to the defrost system but is likely due to a leak fro...

December 1st, 2023

Sign Up to View Full Expert Answers

Create an account to view answers and interact with the community!

🔌Related Questions

I have a double oven, model #SC302T. After cleaning either oven, the thermal switch trips and a reset of the switch is necessary. How can I fix this problem permanently?

October 30th, 2023

I have a GE 3.5 cubic feet washer, Model# WJRE5500GWW, purchased 12/26/08. There is a small leak showing up on the tile floor coming from under the right-front side of the machine. I have checked off the Troubleshooting Tips on Water leaks in the Owner's Manual, and everything is dry behind the machine. Additionally, the agitator is making a new clicking sound during the wash. What should I do?

December 5th, 2023

Refrigerator model # XXXXX Serial # XXXXX has issues with its TurboCool and CustomCool settings. The Citrus setting does not work, causing items to freeze solid in the bin, and liquids on lower shelves of the door are icing up. The temperature at the top of the door reads 38 degrees, and the freezer reads 0 degrees (even after adjusting to 2 degrees). The unit is about 8 years old. What could be causing these issues and what can be done to fix them?

November 24th, 2024

My Kenmore Quiet Wash Type 13743k dishwasher is taking more than 3 hours to complete a cycle. The diagnostic cycle showed no error codes, the filter is clean, and the water temperature is hot. The model number is 665.14743k601. What could be causing this issue and what steps can I take to diagnose and potentially fix it?

May 24th, 2023

I have a Frigidaire FCCW3000FS4 washing machine. The cycle begins and fills, spins, etc., but when water is pumped out, the pump continues to run and the cycle sits until manually advanced. The cycle continues, but once the pump is engaged again, it continues to run until the end of the cycle. I have replaced the speed control board, timer, door switch, and cleaned the pump and hoses. What could be causing this issue?

March 8th, 2024