Jared S. asked
My top-loading washer, about 11-12 years old, fills with water and drains but won't spin or agitate. What could be the issue and what steps can I take to troubleshoot and potentially fix it?
August 24th, 2024
Bradley M. answered
The issue could be due to a faulty lid switch or a faulty inverter on the motor. Here are the steps ...
August 24th, 2024
Create an account to view answers and interact with the community!
My Thermador MED302 ES/8 oven lost power after a power surge. I checked the power at the wall and it's good. I suspect it might be the power supply or power control board. Where can I get a service manual and how can I diagnose the problem?
March 30th, 2023
I have a Turbo Air TCB-3SD Kegerator with a slow refrigerant leak. I need to recharge it with R-134a and would like to use a leak saver product while recharging. I have an extreme power 3cfm vacuum pump manifold kit, a can of R-134a, and a leak saver 5T sealant. I am unsure how to proceed with the recharging process and whether to use the leak saver product. Additionally, the unit has been making unusual noises and is not cooling properly. What steps should I take to recharge the unit and troubleshoot the issue?
January 27th, 2024
My GE JVM617SSK3SS microwave, manufactured in November 2019, has a 'reset filter' light on. I removed and replaced the mesh filter, but the light remains on. What should I do to turn off the 'reset filter' light?
September 20th, 2023
My water is not draining out. The tub is full of water. I have been dealing with this issue for 1 week. I checked my hose and it is not bent. The tub is fine but I hear the water swishing around under the tub when I took out the clothes. The brand and model of my tub is Maytag Neptune. I have tried checking the drainage hose and turning on the spin cycle, but nothing came out. How do I get the water out of my washer?
February 25th, 2023
When trying to start the wash cycle, the water does not start. The appliance is a Kenmore top-loading washer model 23102, several years old. This is the first time this has happened, and normal starting procedures have been tried. What could be the issue and what should be checked?
January 1st, 2024