asked

My Whirlpool refrigerator (model WRF736SDAM12, 3 years old) is short cycling, turning on and off every 3-4 seconds. The fan near the ice maker starts and stops repeatedly. What could be causing this issue, and what steps should I take to fix it?

April 29th, 2023

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

My GE refrigerator (model GSH25JSXBSS, 9 years old, serial # MR224072) runs continually. There is no frost, water dripping, and the fan is on. What could be the issue and what steps should I take to diagnose and potentially fix it?

March 20th, 2024

My KitchenAid KCMS2055SSS-1 microwave starts, lights work, convection fan works, but it does not heat the food. The microwave was manufactured in 2008. I plan to do the work myself and am considering either buying a new one and installing it or replacing parts if they are readily available. I would prefer an exact dimensional replacement to make the job easier. What should I do?

January 8th, 2024

I have a Dacor ECD230 Double Oven. The upper oven will not heat on any cycle (bake, broil, or convection). I have performed the voltage tests for each cycle as outlined by Dacor and measured 240 volts for all of them. I have also checked and pushed the reset on the HTC switch, but it did not feel like it was tripped. While I had a bake cycle on, I attempted to measure across the HTC terminals, but my meter showed just stray millivolts. Should I be able to measure 240v across those terminals? Is a bad HTC the next step? Should I be looking at something else? Prior to the current situation, we had lost the convection cycle, and after replacing the element, we also lost bake. The dealer diagnosed a double fault on the upper relay board and said it needed to be replaced. I elected to replace it myself, but the issue persists.

May 31st, 2024

All the pilots are not working on my Jenn-Air gas cooktop. What is going on?

April 5th, 2024

I have a Maytag LGD 612 dryer. The new motor has different wire connections. Do you plan on doing the work yourself? Is there anything else we should know to help you best?

October 20th, 2024