asked
We just bought a Whirlpool stainless steel dishwasher from Lowe's, model WDT750SAH-ZO. We could not find the plastic caps needed to attach the dishwasher to the sides of the cabinet after changing our countertop from laminate to quartz. What should we do to get these caps?
June 9th, 2024
Kenmore Dryer (###) ###-#### stopped heating a week ago. The dryer was installed new in 2006. I have tried the following troubleshooting steps: vacuumed out the interior of the dryer, cleaned the flexible vent tube between the dryer and wall, disassembled the lint screen assembly and vacuumed it out, performed diagnostics at the control panel which resulted in an F-28 fault display, tested the thermal fuse (and replaced it), tested the thermistor and moisture sensor wire harness, and tested the moisture sensor strips. The moisture sensor strips yielded a continuous shrilling noise when bridged with a wet cloth, and the display changed to 9 and then 6 during the test. I have ordered new thermistor and moisture sensor strips. What else could be causing the no heat condition, and is there anything else I should check or replace?
November 7th, 2023
My Centennial top-loading washer, about 10 years old, will not go past the wash mode. I tried running the diagnostic code generator and found codes F8E1 and 'no fill, long fill.' The water is hooked up, and the pressure is fine. What could be the issue, and what steps should I take to diagnose and potentially fix it?
May 3rd, 2023
My Whirlpool Estate Dryer Model EED4400WQ0 (serial # M03555991) is not drying loads properly. It takes too long and the clothes are not getting hot enough. There is also a clinging noise heard during operation. What could be the issue, and what is the estimated repair cost?
November 23rd, 2023
I am having trouble loosening the screws for the bake element cover on my Maytag oven, model MER8674AW, which was purchased in March 2013. The oven has not been heating properly for a week, and the bake element has been replaced since purchase. What type of tool should I use to loosen the screws on the plate cover on top of the bake element?
December 15th, 2023
The middle part of my GE top-load washing machine doesn't move after the water is filled in the machine. It just sits there with the clothes until it's time for the water to spin out. My clothes are not being washed. I suspect I may have overloaded the machine. What should I do to fix this issue?
October 16th, 2023