William M. asked
I have a GE PSS26MST SS refrigerator, approximately 7 years old. The freezer temperature is always too cold, ranging from -7 to -22 degF, while the refrigerator shows the recommended temperature of 37degF. Some produce is freezing in the lower drawers. I replaced the freezer temperature sensor (part number WR55X10025), but the issue persists, and now the freezer temperature is even lower, around -15 to -20 degF. Additionally, the ice dispenser won't open the door, and the water dispenser has stopped working. Ice is forming on the lower inlet, making the lower bin unusable. What else can I do to resolve these issues?
August 23rd, 2023
Brian M. answered
Replacing the freezer temperature sensor did not resolve the issue, and the problem has worsened. Th...
August 23rd, 2023
Create an account to view answers and interact with the community!
My Maytag model MFT2673BEM10 started with a pinched water line and a ticking noise from a solenoid (water valve). Now, the control panel is flashing with the water glass icon and beeping every 10 seconds. The control panel is not working correctly. If I open one of the doors, the compressor kicks in, but it stops after a couple of seconds when I close the door. What could be the issue?
May 24th, 2024
My Maytag Econoservs (Maytag Commercial Technology) washer, which is 5 years old, has a loose drum. I plan to do the work myself. What could be the issue and what steps should I take to fix it?
July 12th, 2023
I am a new laundromat owner and I had to replace the coin counter board with part F0370410-10P. It came with a price of $1.50 preprogrammed, and I would like to change that to $2.25. Can you give me instructions on how to do that with the new board?
September 18th, 2024
What would be a middle-of-the-road reasonable total price for replacing the rear bearings in an LG front-load washer, and do I need to replace both the inner and outer bearings along with the seal if the machine is not leaking?
April 8th, 2024
I have an older front load Maytag Neptune washer, coin operated. The clothes suddenly started to be left very wet when the cycle finished, and it never gets up to full speed. Just does a slow sing right to the end. I checked and do not see anything blocking the drain pump, and I also replaced the motor control board less than a year ago so I doubt it is either of those problems. What could be causing this issue and how can I fix it?
March 19th, 2024
