asked
I have a Maytag clothes washer that is leaking under the bottom of the water pump in the back right corner where the water hose connects. The washer is around 10 years old, model #PAV2300AWW, and serial #12364374YM. I have already taken the water pump out, and I am wondering if it could be a defective water pump. Where can I get a replacement in the Visalia, California 93292 area?
August 6th, 2023
The oven on our GE stove was turned on to clean the drippings/deposits on the bottom of the oven and ran for the time recommended. However, my wife forgot to remove the silicon protector pads that were on the front edges of the racks. When we opened the oven to check on the results of cleaning, we found everything inside was coated with a gray substance that is like a powder that clings to racks, oven walls, and inside of the door and glass. We vacuumed what would come off. The main problem is the door and glass which we tried to wipe off with detergent, but not successfully. What advice can you give us to clean this up?
August 21st, 2024
My ice maker won't dispense ice cubes, it makes them but won't dispense them. The power went out last week in a storm and hasn't worked since. I replaced the filter about 4 months ago. The ice maker is from 2012 and has had no problems until now. What could be the issue and what should I check or replace?
March 10th, 2023
I have a GE Profile gas stove that is only 2 years old. The side panel on the oven door has come apart, and the oven does not heat properly. What can be done to fix this issue?
February 27th, 2023
My 20-year-old electric GE Profile oven is displaying an F2 error during the cleaning cycle. I have pressed the off button, but the error persists. How do I get the oven to stop cleaning, and is there a risk of fire?
October 20th, 2024
Good morning Pearl, I have a Whirlpool Cabrio washer. When plugged in, it makes a buzzing noise that continues for a short time after being unplugged. The lid will not lock when the machine is plugged in and turned on, and it is stuck in the sensing mode. The machine filled with water but does nothing else. What could be the issue and how can I fix it?
February 2nd, 2023