Elizabeth B. asked
I have a Whirlpool front load washing machine that stopped mid-cycle, left water in the drum, and did not complete the spin cycle. I'm receiving error messages E02 and F01. The drum spins smoothly, and I've checked the wires, but the machine still doesn't work correctly. What could be the issue, and how can I fix it?
April 6th, 2023
Veronica R. answered
The error messages E02 and F01 indicate that the motor control unit (MCU) is not correctly reading t...
April 6th, 2023
Create an account to view answers and interact with the community!
My GE Profile side-by-side refrigerator, model #PSS26PSTASS, has a freezer temperature that stays at -3F to -4F despite being set to 0F, as recommended. Additionally, ice continually forms in the refrigerator above the bottom drawer, which then thaws and causes water to collect in the bottom of the refrigerator. We have already replaced the motherboard and the thermostat. What could be wrong, and what steps can be taken to fix it?
May 4th, 2024
My dryer's igniter stays lit for about 45 seconds, then the flame stays on for 20 seconds before going out. I've changed the gas coils and the gas valve, but the issue persists. The igniter has been burning for about 3 minutes without igniting the flame, and the front cover is off. What could be the problem?
September 5th, 2024
My Kitchenaid 'Superba?' KUDS01FL dishwasher works great but won't start after sitting for a while. The LEDs do not blink to indicate the start of a cycle, but the cancel cycle always works. The machine will usually run any program after reassembling the door/control panel. Does this machine have a memory that can be cleared?
February 14th, 2023
My Miele dishwasher works most of the time, but sometimes it stops before the soap dispenser opens and the INTAKE/DRAIN light flashes. It usually works if we start it again. Can you diagnose this problem?
September 6th, 2024
I have a Samsung dishwasher model # ***** that always stops and starts flashing 'smart auto' no matter what wash mode I set. I have tried resetting it by shutting off the power, but it didn't work. The manufacturer suggested it might be a water supply fault code, but my water supply is fine. The dishwasher supplies water for 3-5 seconds, then drains for another 3-5 seconds before stopping and flashing the code. What could be causing this issue and how can I fix it?
September 4th, 2023