asked
I have an LG gas dryer with a damaged power button on the control panel. Is there a replacement for the power button, or do I need to replace the entire control panel? The model number is *. The dryer is not showing any error codes, but I can't turn it on or off due to the damaged button.
May 2nd, 2023
I bought a Maytag MNWX655DW0, a top-loading washer, which is brand new. It seems to have a problem with not getting all the water out during the spinning cycle, making drying take longer. This issue has been going on for a couple of weeks. I have tried the drain and spin cycle but it still doesn't remove enough excess water. I don't have a manual and am unsure if there's something specific I should be doing. What could be causing this issue and what steps can I take to resolve it?
March 21st, 2024
Hi there. My Icon model EDW7505HPS0A dishwasher won’t drain and is displaying error code 11. I tried draining the water manually with a vacuum, cleaned everything, and attempted to run it again, but it stopped after about 2 minutes and is still flashing “Er 11”. What could be the issue and what should I check or do?
February 17th, 2023
There is water leakage under the fridge at intervals even though the water to the icemaker is off. The model is 26CFTFHP SXsss. The ice maker and water filter were just replaced about 6 months ago, and the issue has been ongoing for about 4 months. What could be causing the leakage and what can be done to fix it?
July 8th, 2023
I have a new top-loading washing machine that is non-agitator and has a water-saving design. It twists my clothes into knots during the sensing cycle and does not rinse the soap off my clothes properly, even after running an extra rinse cycle. I've tried increasing the water level to max, but it often cancels the cycle and drains, forcing me to start again. The machine also frequently becomes unbalanced. Am I doing something wrong, or is there an issue with the machine?
March 20th, 2024
After replacing the display module on my JennAir JDS9860BDB Dual-Fuel range, the touch board functions for about 30 seconds and then stops. If I unplug the ribbon connector and plug it back in, the touchpad works again for about 30 seconds. If I touch a short series of buttons while the touch panel has stopped functioning, then unplug/replug the ribbon connector, the display will run through those commands. The ribbon looks okay. What could be causing this issue and what can I do to fix it?
December 1st, 2024