Mandy R. asked
I'm having trouble with my Maytag MVWB850YW0, which is 7 years old. The issue started last night, and I've verified that I have water and power, the water stream is strong, the tub fills and drains, and the lid locks. I performed a diagnostic using the 3-second hold and 3-second release method, and there are no F codes, but it displays C0 at the end. The washer won't start a cycle consistently; it sometimes starts for a few seconds, with the longest being 3 minutes in clean washer mode. What could be the problem, and what should I do?
November 14th, 2024
Joshua T. answered
The issue you're experiencing is likely due to a faulty electronic control board. Here are the steps...
November 14th, 2024
Create an account to view answers and interact with the community!
I have a Kenmore Model 665.13222N412 dishwasher. The circulating (wash) pump doesn't operate on any cycle. A technician said the circulating pump was bad and would change it out for $360. After checking, the pump operates fine. I want to check if a fuse is blown. How do you do that? Also, do you have any other ideas I could try?
April 4th, 2024
My Whirlpool GI6FDRXXY02 refrigerator is freezing vegetables in the crisper drawers and has stopped making ice. The issue with freezing has been intermittent for a few months, and the ice maker stopped working entirely recently. What could be the problem, and how can I fix it?
April 18th, 2023
If the valve/burner assembly (part number 279894) had to be replaced in my Whirlpool dryer, is there other piping inside of the dryer that would have to be changed or piping coming to the dryer that would have to be changed?
September 29th, 2023
I have a GE front load washer that is about 8 years old. It just shut off and won't power back on. I tried to unplug it for a bit and reset all the breakers. It will not turn back on. The door is locked with all my good towels in it too. What could be the issue and how can I fix it?
July 14th, 2024
My Whirlpool washer shows the command 'LOC' and shuts off when I try to turn it on. It's a front loader, about 6 months old, and none of the buttons respond. What should I do?
May 6th, 2023
