asked

My Kenmore Elite dishwasher model 665.13969k014 refuses to start washing dishes. When I push start and close the door, the 'add a dish' light begins to flash continuously. I have checked the loads to ensure the door closes properly and reset the circuit breaker, but the issue persists. What could be causing this and how can I fix it?

December 25th, 2023

Sign Up to View Answers

Create an account to view answers and interact with the community!

Related Questions

My Whirlpool refrigerator (model WRF736SDAM12, 3 years old) is short cycling, turning on and off every 3-4 seconds. The fan near the ice maker starts and stops repeatedly. What could be causing this issue, and what steps should I take to fix it?

April 29th, 2023

My GE refrigerator (model GSH25JSXBSS, 9 years old, serial # MR224072) runs continually. There is no frost, water dripping, and the fan is on. What could be the issue and what steps should I take to diagnose and potentially fix it?

March 20th, 2024

My KitchenAid KCMS2055SSS-1 microwave starts, lights work, convection fan works, but it does not heat the food. The microwave was manufactured in 2008. I plan to do the work myself and am considering either buying a new one and installing it or replacing parts if they are readily available. I would prefer an exact dimensional replacement to make the job easier. What should I do?

January 8th, 2024

I have a Dacor ECD230 Double Oven. The upper oven will not heat on any cycle (bake, broil, or convection). I have performed the voltage tests for each cycle as outlined by Dacor and measured 240 volts for all of them. I have also checked and pushed the reset on the HTC switch, but it did not feel like it was tripped. While I had a bake cycle on, I attempted to measure across the HTC terminals, but my meter showed just stray millivolts. Should I be able to measure 240v across those terminals? Is a bad HTC the next step? Should I be looking at something else? Prior to the current situation, we had lost the convection cycle, and after replacing the element, we also lost bake. The dealer diagnosed a double fault on the upper relay board and said it needed to be replaced. I elected to replace it myself, but the issue persists.

May 31st, 2024

All the pilots are not working on my Jenn-Air gas cooktop. What is going on?

April 5th, 2024