April C. asked
My Samsung top loader washer will run a wash cycle but when it is time for the spin cycle, it displays 'NF' and is full of water but won't spin. When I restart the washer, it drains the water and then refills the drum. I don't have an option for just a spin cycle. It seems to be adding more water than usual, but that may just be due to the weight of wet clothes.
July 28th, 2023
Megan F. answered
The 'NF' code on your Samsung washer indicates a no fill issue, and the excessive water filling sugg...
July 28th, 2023
Create an account to view answers and interact with the community!
I have an issue with my Kitchenaid KUIC18NNTS1 ice maker. The recirculation pump seems to be bad, and during the test, the ice maker shuts off. What could be the problem and how can I fix it?
March 22nd, 2023
I have a Whirlpool front load washing machine that stopped mid-cycle, left water in the drum, and did not complete the spin cycle. I'm receiving error messages E02 and F01. The drum spins smoothly, and I've checked the wires, but the machine still doesn't work correctly. What could be the issue, and how can I fix it?
April 6th, 2023
My GE Profile side-by-side refrigerator, model #PSS26PSTASS, has a freezer temperature that stays at -3F to -4F despite being set to 0F, as recommended. Additionally, ice continually forms in the refrigerator above the bottom drawer, which then thaws and causes water to collect in the bottom of the refrigerator. We have already replaced the motherboard and the thermostat. What could be wrong, and what steps can be taken to fix it?
May 4th, 2024
My dryer's igniter stays lit for about 45 seconds, then the flame stays on for 20 seconds before going out. I've changed the gas coils and the gas valve, but the issue persists. The igniter has been burning for about 3 minutes without igniting the flame, and the front cover is off. What could be the problem?
September 5th, 2024
My Kitchenaid 'Superba?' KUDS01FL dishwasher works great but won't start after sitting for a while. The LEDs do not blink to indicate the start of a cycle, but the cancel cycle always works. The machine will usually run any program after reassembling the door/control panel. Does this machine have a memory that can be cleared?
February 14th, 2023